Released: 08/29/2007

The following printer families are supported :

Printer Manufacturer
Avery DennisonCAB/GeminiCitizen
C.ItohDatamax/FargoGodex
HPIntermecNovexx
PostscriptPrintronixRJS
SATOSystemwaveTEC
THAROTSCZebra
Any Windows Printer Driver

Important Note:

As of Version 5.7.0 EASYLABEL will only install on Windows 2000 or higher. Windows 95, Windows 98, Windows ME and Windows NT are no longer supported. EASYLABEL 5.6 should be used on Windows 98, Windows ME and Windows NT. Windows 95 is not supported.

Important Note:

If you used Visual Studio 2003 to compile a project using EASYLABEL’s ActiveX objects with version 1.1 of the .NET framework, you may experience a crash when you run your project after upgrading to EASYLABEL 5.7.0 This is because the project tries to load .NET framework version 1.1 and then tries to load .NET framework version 2. This loading of the second .NET framework fails and that causes the crash. To correct this, compile your project using Visual Studio 2005. If this is not possible you can correct the problem if you un-install version 1.1 of the .NET framework.

The following changes/additions have been made :

1. Peel-off mode not available on some Intermec printers
Corrected a problem where Peel-off mode was not selectable on some of the newer Intermec printers.

2. Unused graphics no longer created or sent
Randomly, the software would create and send barcode graphics of some of the fields on the format. These graphic were not actually used on the label. This has been corrected.

3. Corrections to the “Device Attached” prompt.
In some languages other than English, the selection for the 8 port WTI switch box was missing. This has been corrected. In many languages other than English there was no default selection for the “Device Attached” prompt. The prompt now defaults to “Printer”.